Rate affects overall wound width and wound roughness.Different thicknesses of raw materials, different laser cutting air pressures, the laser cutting rate has a good value, which is about a large laser cutting rate.80%. If the laser cutting rate is too fast, the reasonable spot surface will be reduced immediately. This is because the time for the interaction force between the machine equipment and the raw material is shortened due to the too fast rate.So, what are the requirements for the rate of laser cutting due to the characteristics of fiber laser cutting?Laser processing cuttingLet me give you a detailed introduction.
The laser cutting rate of the machine is too fast, which will cause The overall width of the wound will be reduced, so the direct point of light will be close to it, the wound will continue to have drag lines, the roughness of the wound will immediately increase, and there will continue to be slag scraping. If the rate of laser cutting is too low, the time for the laser and the raw material to act will be lengthened immediately, the total area of the laser spot will also increase, and the total width of the wound will also increase.Laser processing cuttingThe rate is not as fast as the melting rate, and the remaining reaction heat causes the wound to undergo excessive melting, which has a relatively large impact on the heat.
The speed of the laser cutting machine has such a great reputation, so how do we know the speed of fiber laser cutting? Because the laser cutting service platform is short, it is impossible to tell whether it is running at a high speed with eyes. We can use the mobile phone software simulation function of the servo controller of the automatic cutting machine to check whether the speed ratio of the motor is high.in detectionLaser processing cuttingThere is no need to cut the speed, and the interaction speed is improved. Each axis can be detected separately or separately.
